Professional Laminating Systems II Series User Manual download pdf (Page 58)

Section 7: Maintenance 53

Pro/Pro-L Card Printer UserÕs Manual

card from its jam. Try not to move the card too far from where it was just

before the jam occurred. Once the jam is cleared, replace media, close the Top

Cover(s), and press the Pause/Resume button to resume printing.

4. If you would like to remove the jammed card completely, do so by using the

On/Cancel and Pause/Resume buttons to manually eject the card. Then,

replace media, close the Top Cover(s), and press the On/Cancel button. At this

point, the LCD Display will prompt you to either press the Pause/Resume

button or the On/Cancel button. Pressing the Pause/Resume button will cause

the printer to feed in a new card and reprint the job which originally jammed

along with all subsequent jobs still being sent. Pressing the On/Cancel button

will reboot the printer and cancel all jobs within the printerÕs memory. In this

case, you must also cancel and resend the print jobs from your computer.

G. CLEARING A RIBBON OR OVERLAMINATE JAM

If the ribbon (or overlaminate if using Pro-L) becomes stuck to a card or jammed

inside the printer, the LCD Display will indicate that it is jammed. Refer to the

following steps to clear the jam:

1. Leave the power ON, and open the printerÕs Top Cover(s) as necessary.

2. Remove the Take-Up core (the side with used ribbon or overlaminate on it)

from in between the two black Drive Hubs.

3. Steadily pull the ribbon or overlaminate free from where it is jammed. If stuck

to a card, pull the ribbon or overlaminate off the card and throw the card away.

If it is jammed underneath the rollers, press and hold down the printerÕs

Pause/Resume button as you gently pull up on the ribbon or overlaminate. Do

not jerk the ribbon or overlaminate to free it, since this will increase the chance

of breaking it. If it does happen to break, simply tape the broken end of the

supply roll directly onto the take-up roll. Then, wind a few inches worth of

ribbon or overlaminate from the supply roll onto the take-up roll. Be sure the

ribbon or overlaminate is passing beneath both the supply and take-up rolls.

4. Once the jam is cleared, replace media, close the Top Cover(s), and press the

On/Cancel button. At this point, the LCD Display will prompt you to either

press the Pause/Resume button or the On/Cancel button. Pressing the

Pause/Resume button will cause the printer to feed in a new card and reprint

the job which originally jammed along with all subsequent jobs still being sent.

Pressing the On/Cancel button will reboot the printer and cancel all jobs within

the printerÕs memory. In this case, you must also cancel and resend the print

jobs from your computer.

510301_pro_proL 11/24/98 12:03 PM Page 53

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 97 98

No comments

Professional Laminating Systems II Series User Manual Page 58